Sundray Wireless AP-S800 Installation Guide
18 / 20
Notes: In outdoor environment, Ethernet cable must have waterproof cover. It is recommended
to use shielded Cat5 or enhanced Cat5 cable, and the length of the Ethernet cable used to
connect AP to switch cannot exceed 100 meters.
3.7 Waterproof and Lightning Protection
To ensure that access point and feeder lightning arrester are well grounded, refer to
Grounding
and Lightning Protection
section. Make sure that the following joints are wrapped with
waterproof tape: four joints of feeder lightning arresters, four joints between antennas and
feeder lightning arresters, one joint of Ethernet port. For how to wrap joint with waterproof tape,
refer to the attached figure 2.
3.8 Examination After Installation
After the installation and cabling, check the following items before powering access point:
ü
Access point and antenna are installed firmly.
ü
Power source meets the power specifications of the AP.
ü
The access point is well grounded.
ü
Waterproof measures are taken against the each joint of access point.
ü
Unconnected ports on the AP are connected with RSMA-50KR load and then blocked
waterproof plugs.
