SunDash Radius 252, Инструкция по эксплуатации и сборке

Страница: 8 / 40

7
Step 5
Remove panel C from marked “PLC” and locate
on base. Align slots in bottom plate of
panel C with the alignment pins in floor.
Align right side of panel C with left side of
panel B, the side rails of both panels should
nest together. Attach panel C to base with
the two (2) attachment latches by placing
the latch into slot in booth panel. Press
downward on the latch paddle, latch should
snap into place securing bottom of panel C
to base. Attach panel C to panel B with the
upper panel latch, located on the top of panel
B by repeating the above latching procedure.
(See Illustration 5)
Illustration 5
Step 6
Remove Panel D from box marked “PLD” and
stand panel upright into position . Place washer
over both top and bottom hinge pins. Align
hinge pins in door with hinges in Panel C, and
allow hinge pins to drop into hinges. The door
panel will re-hang on booth body.
(See Illustration 6)
Step 7
Locate floor and place over base.
Attach floor to base with safety rails.
By placing safety rail on threaded studs
protruding through floor. Tighten rails securely.
(See Illustration 7 )
Step 8
Remove top fan panel from box marked “ To p”.
Place top fan panel on tanning unit. Attach
top fan panel to tanning unit using the nine
(9) provided 5/16" - 18 x 1 bolts.
(See Illustration 8)
Assembly Instructions
Illustration 7
Illustration 6