SunDash Radius 252, Инструкция по эксплуатации и сборке

Страница: 33 / 40

32
General Troubleshooting Guide
The following troubleshooting information is divided into two sections. Section A contains items in which the
owner may check without the aid of a service person. Section B contains items which must be performed by
QUALIFIED SERVICE PERSONNEL ONLY. If you have any questions other than the ones listed in your
troubleshooting guide, contact your dealer or distributor NOTE : All tanning units are not the same, therefore
some of the causes may not apply to your unit.)
General Troubleshooting (Section A)
1. Tanning unit does not operate.
CAUSE
1. No power to unit.
2. Timer is not activated.
Note: If there is power to the unit but the display on the timer is not lighting, you may need to replace
the timer. Contact JK Global Service or your local represent at ive for information.
2. Lamps will not light or lamps flicker.
CAUSE
1. Lamp not seated properly in
lampholder.
2. Faulty lamp.
SOLUTION
1. Check Electrical connection on wiring
diagram and correct as necessary.
2. Replace
3. Replace
4. Check wiring circuit against
appropriate diagram and correct as
required.
SOLUTION
1. Remove lamp, inspect contact on lamp,
and reinstall lamp securely into
lampholder.
2. Replace lamp. (Refer to Instruction
Manual for correct lamp.)
General Troubleshooting (Section B)
All services in the following section are to be completed by a Qualified Servic e T echnician. This section is to
aid in isolating and correcting problems which may occur and is not intended for the use by the owne r. Refer
to the assembly instructions included with each unit for reference in disassembling and wiring the tanning
unit. Disconnect all power to the unit before servicing. Use only factory authorized components for replacement
parts.
1. Tanning unit does not operate.
CAUSE
1. Incorrect connection of incoming
power.
2. Faulty Timer
3. Faulty relay in unit.
4. Poor wiring connections.
SOLUTION
1. Check circuit breaker servicing unit.
2. Press up button, then start button.
2. Lamps will not light.
CAUSE
1. Poor wiring crimp at the lampholder.
2. Faulty or damaged lampholder.
3. Incoming power to the unit is incorrect.
4. Faulty Ballast
5. Loose power wire to ballast.
SOLUTION
1. Check for loose wire and re pai r.
2. Replace lampholder
3. Check incoming voltage and correct to
requirements.
4. Locate and replace
5. Locate loose wire and re pai r.