Page 38
680 EXPORT SERIES
Expert winterization of your spa is highly recommended, contact your
authorized Sundance dealer. In emergency situations, damage can be
minimized by taking the following steps:
CAUTION: TURN OFF POWER TO HOT TUB!
1. Turn off power to the spa.
2. Follow the directions on page 35 for draining the spa.
3. Turn the massage/diverter selector(s) into the middle combo position
to allow the water in the plumbing lines to drain, see page 29.
4. Turn the waterfall valve to the open position to allow the water in the
plumbing lines to drain, see page 29.
5. Open all the air controls and leave them open until you resume use
of the spa, page 29.
6. As the water level drops below the seats, use whatever means
necessary to get the water out of the recessed seating areas and into
the footwell, such as a wet/dry vacuum.
7. When the water level ceases to drop, use whatever means available
to remove any remaining water from the footwell, such as a wet/dry
vacuum.
8. Remove the equipment-side cabinet panel and locate the drain plugs
in the front of the pump(s) (Figure A, page 16). Remove these
plugs to allow the water to drain out of the pumps and heater.
Note:
Approximately one to two gallons will be released during this
procedure. Use a wet/dry vacuum or other means to keep this from
flooding the equipment compartment. Replace the pump drain plugs.
9. Loosen hose clamp at bottom of CLEAR
RAY
® system and pull hose
off of CLEAR
RAY
fitting (twist the hose back and forth while pulling
downward). Tip hose down and allow to drain, then reinstall hose
and clamp. Remove the cover of the CLEAR
RAY
system to access
the UV bulb and quartz tube. Remove and store the UV bulb in a
safe location. Remove and dry off the quartz tube then reinstall it.
Depending on the length of time, consider replacing the UV bulb
when you resume use of your hot tub.
10. Re-install cabinet side panels and cover spa so that no casual
moisture can enter into it.
Consult your authorized Sundance dealer if you have any questions
regarding winter use or winterizing.
11.8
Restarting Your Spa in Cold Weather
If you want to start up your spa after it has sat empty for a time in
freezing temperatures, be aware that the water remaining in certain
sections of the piping may still be frozen. This situation will block water
flow preventing the spa from operating properly and possibly damaging
the equipment. We recommend you consult your authorized Sundance
dealer for guidance before attempting to re-start your spa under these
conditions.
Содержание Denali 680 Series
