7
Sundance Spas Gazebos Installation Instructions WillowWood
Step 11
Closing the Wall Sections
Place the two completed wall sections
opposite of each other as shown in
Diagram 11.
Join the two wall sections as in Step 9,
making sure to attach wall sections to
the INSIDE of the corner upright of the
adjoining wall. Attach the wall section
with four 2-1/2" screws but DO NOT
tighten the screws at this time.
Pro Tip:
You will need an assistant for
the next step.
Step 12
Squaring the Gazebo Walls
The completed wall assembly must be
square for the roof assembly to fit
properly. To check if the assembly is
squared, measure diagonally between
opposite corners as shown in Diagram 12.
If the measurements are equal, the
assembly is square. If the measurements
are not equal, re-align the unsecured
corners and measure again. When the
walls are squared properly, then
completely tighten all the screws in the
corner uprights.
Pro Tip:
Take your time on this step and
do it right. The time you take to square
the walls at this step will save you time
and effort during roof assembly.
Diagram 11
Diagram 12