Sun Nuclear Radon 1028, Руководство пользователя

Страница: 15 / 68

9
Starting a Test
When the “Start Test = 5” prompt appears, press the 5 button to start a new test.
Interrupting a Test
A test in progress can be interrupted to view the average or current readings.
After the interruption, the test can be terminated or continued.
Press… Display Shows… Comment
–
Start Test = 5
A new test can be started.
Checking Memory
Memory is rechecked. If data is found, memory
must be cleared before starting a new test. See
Clearing Memory on page 11.
–
Delay 0 hr
Displays the time delay defined in Setup.
–
Interval 1 hr
Displays the measurement interval defined in
Setup.
–
Duration 12 hr
Displays the test duration defined in Setup.
–
Test in Progress
The test has started and will be finished after the
duration defined in Setup (plus delay). The display
turns off after a few minutes and remains off until
the test is interrupted or the display is turned on.
Press… Display Shows… Comment
Battery OK
Display turns on and battery is checked.
–
Enter PIN
This prompt only appears if a Personal Identification
Number was set up.
nnnn
NNNN
Enter the PIN using only digits 1 through 4.
NNNN
PIN number is displayed. Press PIN button (5) to
check PIN. If the wrong PIN is entered, the mes-
sage “ Shutting down.. .” is displayed.
–
End Test Y=5 N=2
Press 5 to end a test prematurely or 2 to continue.
Pressing 2 will turn off the display and continue the
test.
Note, when this message is displayed, the user
also has the option to press AVG (3) or CUR (4) to
display the average or current readings. See AVG or
CUR During a Test , below.
Confirm Y=5 N=2
Press 5 to confirm or 2 to cancel.
Test Complete
The test is terminated.
–
Start Test = 5
A new test may be started. If there is partial test
data in memory, it must be cleared before starting
a new test. See Clearing Memory on page 11.