Sun Microsystems ZFS, Руководство по установке

Страница: 93 / 108

To perform initial configuration using serial, connect a serial cable from the SER MGT port on the
back panel of the controller to the serial port on the administrative client. Use a DB9 to RJ45
adapter if necessary.
To perform initial configuration using Ethernet, connect an Ethernet cable from the NET MGT
port on the back panel of the controller to your network.
Connect an Ethernet cable from your network to the NET0 port on the back panel of the
controller.
For 7120, 7320 and 7420, power on any disk shelves attached to the storage system by plugging
the two power cords into the universal power connectors, connecting the cords to the external
power source and turning on the disk shelf power switches. Wait several minutes until the
power indicators are lit a steady green.
For 7700/7720, ensure that the circuit breakers are in the OFF position before connecting the six
power cords for the storage rack to wall sockets that are controlled by individual circuit
breakers. Connect three of the circuit breakers to one power source, and connect the remaining
three to a different power source. This is required to maintain power protection through
redundant power sources. See
Cabinet Electrical Specifications .
For 7120, 7320 and 7420, connect power cables to power supply 0 and power supply 1 on the
storage controller(s) and wait until the Power/OK LED on the front panel next to the Power
button lights and remains lit (approximately two minutes).
For 7700/7720, switch all of the wall circuit breakers to the ON position. Wait until the
Power/OK LEDs light and remain lit.
Open a terminal window or terminal emulator and issue the appropriate command, as follows:
For a serial port concentrator connect (for example, using telnet), and use root as the user name
and replace
serial-concentrator portnumber with the appropriate value, for example:
telnet
serial-concentrator portnumber
For a network connection, connect using SSH and use root as the user name and determine the
IP address by accessing your DHCP server for the address assigned to the Service Processor MAC
address (see the label on the storage controller), for example:
ssh root@192.168.128.256
Type the password
changeme
when prompted.
At the command prompt, type
start /SP/console
.
Type
y
to confirm that you want to start the console.
Press any key to begin configuring the appliance. The shell interface configuration screen
appears. NET-0 at the top of the screen should be underlined.
1
2
3
4
5
6
7
8
9
10
11
12
Power
Chapter 4 • Powering On and Configuring the System 93