Chapter 1
Setting Up the Sun Fire X2250 Server Hardware
5
3. Connect any additional external devices to the server’s other connectors.
FIGURE 1-2
Back Panel
Powering On and Off the Server
You only need to apply standby power to the server at this point so that you can
perform initial configuration of the service processor. Procedures for powering on to
main power mode and for shutting down from main power mode are also included in
this section, for your reference.
TABLE 1-1
Back Panel
Label
Connector/Slot
Label
Connector/Slot
1
AC Power connector
6
Gigabit Ethernet ports (LAN-0 top, LAN-1
bottom)
2
Network Management (NET MGT) Ethernet
port
7
Locate LED
3
Serial Management (SER MGT) / RS-232-F
RJ-45 serial port
8
Fault LED
4
USB 2.0 connectors (2)
9
Power LED
5
On-board HD15 video connector
10
PCI Express slot
2
10
9
6
3
4
5
7
8
1
