Sun Microsystems Sun Fire V880z, Инструкция по установке и эксплуатации

Страница: 44 / 128

28 Sun Fire V880z Server and Sun XVR-4000 Graphics Accelerator Installation and User’s Guide • May 2003
Note – Only do this with Sun XVR-4000 graphics accelerators where the green LED
fails to illuminate.
20. Close the Sun Fire V880z server enclosure door.
a. If you removed the side door, remount it to the chassis.
Position the side door mounting pins over the corresponding holes in the chassis
rear panel and lower the side door into place.
b. Close the side door.
Make sure that the door is firmly seated in its frame.
c. Lock the side door with the system key.
21. Boot the system to the
ok
prompt and see if the Sun Fire V880z server detects the
Sun XVR-4000 graphics accelerator.
For example, to list your system graphics, type:
If the Sun XVR-4000 graphics accelerator is not detected, power down the system
and apply thumb pressure to the center of the Sun XVR-4000 graphics accelerator
board and note if any additional board travel is experienced.
Note –
Never attempt to re-seat a Sun XVR-4000 graphics accelerator with power
applied to the system.
If the board is not completed seated, push the board fully into place.
Note –
Only do this with Sun XVR-4000 graphics accelerators that are not detected
at the
ok
prompt.
If errors, note the serial number and revision level of the Sun Fire V880 enclosure
and that of the motherboard. Report information to Sun Support Services at:
http://www.sun.com/service/online/
ok show-displays
a) /SUNW,zulu@4,0
b) /SUNW,zulu@1,0
c) /pci@9,600000/TSI,gfxp@1
q) NO SELECTION
Enter Selection, q to quit: q