Sun Microsystems Sun Fire V480, Руководство администратора

Страница: 162 / 270

134 Sun Fire V480 Server Administration Guide • February 2002
2. Connect a Category-5 unshielded twisted-pair (UTP) cable to the appropriate
RJ-45 connector.
You should hear the connector tab click into place. The UTP cable length must not
exceed 100 meters (328 feet).
3. Connect the other end of the cable to the RJ-45 outlet to the appropriate network
device.
You should hear the connector tab click into place.
Consult your network documentation if you need more information about how to
connect to your network.
What Next
If you are installing your system, complete the installation procedure. Return to
Chapter 1.
If you are adding an additional network interface to the system, you need to
configure that interface. See:
■
“How to Configure Additional Network Interfaces” on page 152
How to Access the System Console via
tip
Connection
Before You Begin
The following procedure assumes you are connecting to the serial port (
ttya
) of the
Sun Fire V480 system using a
tip
connection from serial port B (
ttyb
) of another
Sun server, and that the other Sun server has its own local graphics terminal.
What to Do
1. Decide whether you need to reset OpenBoot configuration variables on the Sun
Fire V480 system.
Certain OpenBoot configuration variables control from where system console input
is taken and to where its output is directed.