Sun Microsystems Sun Fire B1600 Administration, Руководство администратора

Страница: 260 / 402

4-62 Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003
4.3.6 Line Commands
You can access the on-board configuration program by attaching a VT100 compatible
device to the switch’s serial port. These commands are used to set communication
parameters for the serial port or Telnet (a virtual terminal).
Note –
The connection parameters for the serial interface are fixed at 8 data bits,
1 stop bit, no parity, and 9600 bps.
4.3.6.1 line
Use this command to identify a specific line for configuration, and to process
subsequent line configuration commands.
Syntax
line
{
console
|
vty
}
■
console
– The console terminal line.
■
vty
– A virtual terminal for remote console access (Telnet).
TABLE 4-11
Line Commands
Command Function Mode Page
line
Identifies a specific line for configuration and starts
the line configuration mode GC 4-62
login
Enables password checking at login LC 4-63
password
Specifies a password on a line LC 4-64
exec-timeout
Sets the interval that the command interpreter waits
until user input is detected LC 4-66
password-thresh
Sets the password intrusion threshold, which limits
the number of failed logon attempts LC 4-66
silent-time
*
* This command only applies to the serial port.
Sets the amount of time the management console is
inaccessible after the number of unsuccessful logon
attempts exceeds the threshold set by the
password-
thresh
command
LC 4-67
show line
Displays a terminal line's parameters NE,
PE 4-68