Sun Microsystems StorEdge T3+, Руководство по установке и настройке

Страница: 79 / 228

Chapter 5 Preparing to Install 57
6. Make sure that all the disk drives, the power and cooling units, the interconnect
cards, and the controller card (if present) are firmly seated in the unit.
7. Replace the front panel.
Caution –
You must replace the front panel for the array to meet regulatory
emissions requirements.
▼
To Edit the Host Files
The JumpStart™ feature automatically downloads the assigned IP address to the
array. To enable this feature, you must edit your host file before cabling the array.
After you cable the array and power on, the IP address is automatically assigned.
Before you begin, make sure you have the following information:
■
MAC address. See
FIGURE 5-3
for the MAC address location. See Step 1 of the
following procedure for the format of the MAC address.
■
IP address. For this information, contact the person who maintains your network.
■
Array name. This is the user-assigned name of the array you are installing.
Note –
If you are installing an enterprise configuration (partner group), you need
the MAC address that will be assigned only to the master controller unit (also called
master unit). In a partner group, this is the array that is located on the bottom. In
Step 1, enter the MAC address for the master unit. When you install the array in the
next section, make sure that the master unit is placed on the bottom of the
configuration.
Do not use the MAC address of the array that you are placing on the top. In a
partner group, the array that is placed on top is referred to as the alternate master
controller unit or alternate master unit.
To set the network IP address for the array:
1. On a host connected to the same subnet as the array, edit the
/etc/ethers
file by
adding the MAC address and array name.
For example:
In this example:
■
8:0:20:7d:93:7e
is the MAC address.
8:0:20:7d:93:7e
array-name