Sun Microsystems StorEdge T3+, Руководство по установке и настройке

Страница: 106 / 228

84 Sun StorEdge T3+ Array Installation and Configuration Manual • April 2002
3. Use the
vol stat
command to verify that the volume is mounted.
After the volume is mounted, it becomes available to the attached host system.
Note – If you are running on the Solaris 7, 11/99 operating environment or a later
release of the Solaris operating environment, skip Step 4 and proceed to Step 5. Later
versions of the Solaris operating environment automatically recognize added storage
devices without additional command operations.
4. Use the
luxadm(
1M
)
command to recognize the new volume.
The
luxadm(
1M
)
command probes for new devices. Refer to the
luxadm(
1M
)
man
page for more information on this command.
a. Make sure there is a
/dev/es
directory on the host system. If not, type:
The
/dev/es
directory is necessary for running the
luxadm
command.
b. On the host system, type
luxadm insert
:
Note –
If the
luxadm
utility is not available, you must do a reconfiguration reboot
(
boot -r
) to ensure that the host recognizes the new volumes. It is preferable,
however, to use the
luxadm
command for this procedure instead of the
boot -r
command.
:/:<5> vol stat
v0 u1d1 u1d2 u1d3 u1d4 u1d5 u1d6 u1d7 u1d8 u1d9
mounted 0 0 0 0 0 0 0 0 0
# mkdir /dev/es
# luxadm insert