Sun Microsystems StorEdge T3+, Руководство по установке и настройке

Страница: 115 / 228

Chapter 6 Array Installation 93
4. Type
port list
to display the world-wide name (
wwn
).
An example of
port list
output for a partner group:
5. Use the
wwn
from the
port list
output to correlate the volume to the Solaris
environment by using the
format
(1M) utility on the data host.
In the following example, the output for the
format
command would show the
same wwn, listed in the second to last line (
u1
) and last line (
u2
), as the wwn in the
port list
output.
6. On the host, exit the Telnet session by pressing Control and the right bracket (
]
)
symbol (Solaris operating environment only) or using the equivalent command
for your operating system.
This command takes you to the telnet command prompt; type
quit
.
Note –
After multipathing support is enabled and the host is rebooted, from the
host side you will see two paths available to the same volume: a primary path and
an alternate path. This means that if you are using the
format(1M)
utility in the
Solaris environment, you will see two paths for each volume.
This completes the installation process for an enterprise configuration. For
information on available array settings and monitoring options, see Chapter 8 and
Chapter 9.
:/:<7>port list
port targetid addr_type status host wwn
u1p1 1 hard online sun 50020f23000003c3
u2p1 2 hard online sun 50020f2300000341
format
Searching for disks...done
AVAILABLE DISK SELECTIONS:
0. c0t0d0 <SUN4.2G cyl 3880 alt 2 hd 16 sec 135>
/pci@1f,4000/scsi@3/sd@0,0
1. c1t0d0 <SUN-T300-0113 cyl 34145 alt 2 hd 64 sec 128>
/pci@6,2000/SUNW,ifp@1/ssd@w50020f23000003c3,0
2. c2t1d0 <SUN-T300-0113 cyl 34145 alt 2 hd 64 sec 128>
/pci@6,2000/SUNW,ifp@1/ssd@w50020f2300000341,0