Sun Microsystems StorEdge S1 AC100, Руководство по установке и обслуживанию

Страница: 61 / 128

Chapter 2 Preparing for Installation and Assembling the Cables 25
8. Repeat Step 3 through Step 7 to create a second DC input power cable.
You connect the first DC input power cable to DC power source A and the second
DC input power cable to DC power source B as described in “Connecting the Power
Cables” on page 50.
To remove a wire from the DC connector, insert the cage clamp operating lever or a
small screwdriver into the slot directly above the wire and press down (
FIGURE 2-6
and
FIGURE 2-7
).
▼
To Install the Strain Relief Housing
1. Insert the bottom portion of the strain relief housing into the notch on the DC
connector until it snaps into place as shown in
FIGURE 2-9
.
Make sure the strain relief housing snaps into place on the DC connector; you cannot
complete the assembly correctly if the strain relief housing is not secure.
FIGURE 2-9
Inserting the Bottom Portion of the Strain Relief Housing
2. Route the three wires coming from the DC power source through the opening at
the end of the bottom portion of the strain relief housing as shown in
FIGURE 2-10
.