Sun Microsystems StorEdge L280, Руководство пользователя

Страница: 57 / 100

Chapter 3 Product Operation and Configuration 3-5
2. With the write-protect switch facing out of the Autoloader and at the top, load
internal slots by pushing the tape in until it “clicks.” The magazine must be
removed to load the internal slots (
FIGURE 3-3
).
FIGURE 3-3
Internal Slots
3. With the magazine handle facing out the front of the Autoloader, slide the
magazine into the Autoloader until it “clicks” into place (
FIGURE 3-1
on page 3-3).
4. Swing the handle to the left to store.
5. Gently shut the access door.
Note – The
INVENTORY CHECK
utility runs when the access door closes so that an
inventory of storage slot locations can be stored into the autoloader memory. This
process takes approximately thirty seconds. The inventory check will not run if the
door is not completely shut.
3.2.5 Unloading Tapes
1. Remove the magazine by following the steps under “Opening the Door” on page
3-2 and “Inserting or Removing the Magazine” on page 3-3.
2. Push the tape in until it “clicks.” The tape will partially eject.