Sun Microsystems Netra 1290, Руководство администратора

Страница: 27 / 146

Chapter 1 Netra 1290 Server Overview 9
■
Two Gigabit Ethernet ports, NET0 and NET1(RJ-45)
■
Alarms port (DB-15)
■
System controller 10/100BASE-T Ethernet port (RJ-45)
■
UltraSCSI port
■
Up to six PCI+ ports (both 33 MHz and 66 MHz support)
■
Four power supply inputs
Their locations are shown in
FIGURE 1-4
.
FIGURE 1-4
Server I/O Port Locations
The LOM console serial port and 10/100BASE-T Ethernet port can be used to access
the system controller.
Use the console serial port to connect directly to an ASCII terminal or an NTS
(network terminal server). Connecting the System Controller board with a serial
cable enables you to access the system controller command line interface with an
ASCII terminal or an NTS.
Use the 10/100BASE-T Ethernet port to connect the SC to the network.
System Management Tasks
The LOM prompt provides the command-line interface for the SC. It is also the place
where console messages are displayed. Some of the system management tasks are
shown in
TABLE 1-1
.
PCI+ 0-5 slots
SCSI port, 68 pins
Alarms port
NET0 and NET1 ports
10/100BASE-T
LOM/SC port
LOM serial A port
Serial B port