Sun Microsystems Netra 120, Руководство пользователя

Страница: 77 / 200

Chapter 5 Installing the Server Into a Rack 5-13
2. Remove the first, third, and fourth screws from the plastic slide-mounts on the
sides of the server (see
FIGURE 5-11
).
3. Fit the front brackets to the second and third of the tapped holes along the side of
the server (counting from the front of the server towards the rear).
Use the Phillips-head countersunk screws provided. See
FIGURE 5-11
, but do not fit
the rear brackets yet.
Note – Only fit the rear brackets when you have completed steps 1 through 4.
FIGURE 5-11
Fitting the Fixed Mounting Brackets
4. Secure the server to the rack using the front brackets only, but do not fully tighten
the screws yet.
5. Fit the two rear fixed brackets to the two tapped holes at the rear of the server on
each side, using the Phillips-head countersunk screws provided (see
FIGURE 5-12
).
6. Align the screws and tighten them.