Sun Microsystems Ethernet MMF/UTP Adapter, Инструкция по установке и эксплуатации

Страница: 75 / 122

Chapter 3 Configuring
ipge
and
e1000
Driver Parameters 41
▼ To Configure Jumbo Frames Using
ndd
1. Shut down and unplumb the interface.
2. Set the instance number:
In this example, the instance number set is 0.
3. Set the instance to accept Jumbo Frames:
4. Plumb the interface up:
where xx.xx.xx.xx is the IP address of the interface.
▼ To Configure Jumbo Frames in a Linux
Environment
1. Ensure that the
e1000
software is installed.
2. Plumb the Sun PCI-Express Dual Gigabit Ethernet interface:
where xxx.xxx.xx.xxx is the IP address of the interface.
3. Set the MTU for maximum performance:
% ndd -set /dev/ipge instance 0
% ndd -set /dev/ipge accept-jumbo 1
% ifconfig ipge0 plumb
xx.xx.xx.xx
up
#
modprobe e1000
# ifconfig eth2
xxx.xxx.xx.xxx
up
# ifconfig eth2 mtu 8170