Sun Microsystems Ethernet MMF/UTP Adapter, Инструкция по установке и эксплуатации

Страница: 105 / 122

Appendix B Diagnostic Software 71
▼ To Update SunVTS to Recognize the
ExpressModule Adapter
1. Connect a loopback cable.
2. Ensure that the SunVTS software and the
e1000g
driver are installed on your
system.
3. Add the following lines to the
/opt/SUNWvts/lib/conf/netlbtest.conf
and
/opt/SUNWvts/lib/conf/nettest.conf
files:
Using the SunVTS
netlbtest
You must have the Ethernet card and the device driver installed, a loopback
connector in place, and Intervention mode enabled before running
netlbtest
.
netlbtest
cannot run if the network interface is connected to a live network, and
requires that the Ethernet device be configured offline before running the test. Use
the
ifconfig(1M)
command to bring the Ethernet device down before running
netlbtest
.
▼ To Use the
netlbtest
1. Ensure that the SunVTS software and the
ipge
driver are installed on your
system.
2. Connect a loopback cable.
3. Unplumb the interface from the system, using the
ifconfig
command :
where instance is the instance number of the interface.
Refer to SunVTS documentation for instructions on how to run
netlbtest
.
e1000g e1000g 1kbaseT
# ifconfig ipge
instance
down
# ifconfig ipge
instance
unplumb