Sun Microsystems Ethernet MMF/UTP Adapter, Инструкция по установке и эксплуатации

Страница: 59 / 122

Chapter 3 Configuring
ipge
and
e1000
Driver Parameters 25
2. To list all the parameters supported by the
ipge
driver, type
?
.
See
TABLE 3-4
through
TABLE 3-1
for parameter descriptions.
Setting the Autonegotiation Mode
By default, autonegotiation is set to
on
. This means that the adapter communicates
with its link partner to determine a compatible network speed, duplex mode, and
flow control capability.
▼
To Disable Autonegotiation Mode
If your network equipment does not support autonegotiation, or if you want to
specify your network speed, you can set autonegotiation to off on the
ipge
device.
Note –
Disabling autonegotiation mode can cause collisions.
# ndd /dev/ipge
name to get/set ? ?
? (read only)
instance (read and write)
adv_autoneg_cap (read and write)
adv_1000fdx_cap (read and write)
adv_1000hdx_cap (read and write)
adv_100T4_cap (read and write)
adv_100fdx_cap (read and write)
adv_100hdx_cap (read and write)
adv_10fdx_cap (read and write)
adv_10hdx_cap (read and write)
adv_asmpause_cap (read and write)
adv_pause_cap (read and write)
master_cfg_enable (read and write)
master_cfg_value (read and write)
use_int_xcvr (read and write)
enable_ipg0 (read and write)
ipg0 (read and write)
ipg1 (read and write)
ipg2 (read and write)
rx_intr_pkts (read and write)
rx_intr_time (read and write)
accept_jumbo (read and write)
laggr_multistream (read and write)
name to get/set ?
#