Installing Elite3D
3
6. Lower the Elite3D into the chassis (at an approximate 45-degree angle) with one
hand. With your other hand, guide the Elite3D backplate extension tab through
back panel slot 3 (
FIGURE 2
).
7. Pull up on the Elite3D backplate extension tab through the back panel slot
(
FIGURE 2
).
8. While holding up the Elite3D backplate extension tab, lower the Elite3D over the
UPA bus connector on the motherboard (
FIGURE 2
).
FIGURE 2
Installing Elite3D
9. Pushing the Elite3D against the chassis back panel, carefully press both corners of
the board evenly to push the Elite3D interface connector into the motherboard
UPA bus connector.
10. Lock the UPA bus connector retainer clip onto the Elite3D.
UPA bus
connector
Ultra 2
back panel
Back panel slot
Elite3D backplate extension tab
Elite3D backplate extension tab
