Sun Microsystems Blade X6240, Руководство по установке

Страница: 26 / 72

14 Sun Blade X6240 Server Module Installation Guide • June 2008
Note – Option 1 and option 2 enable you to connect to ILOM without knowing
ILOM’s IP address. These options provide access to ILOM’s command-line interface
(CLI) only. Option 3 requires you to know ILOM’s IP address, but supports CLI and
web GUI access. Most users configure ILOM’s IP address, then connect to it using
Option 3.
Instructions for configuring ILOM’s IP address are in “Configuring the ILOM IP
Address” on page 23 .
■
Option 1 . Use the serial connector on the chassis to connect to the CMM ILOM.
Then use the CMM ILOM to navigate to the server module ILOM. See “Option 1:
Connecting to ILOM Through the Chassis Serial Connector” on page 14 .
■
Option 2 . Use a dongle cable to establish a serial connection directly to the server
module ILOM. See “Option 2: Connecting to ILOM Through a Dongle Cable” on
page 18 .
■
Option 3
. Connect through the Ethernet. This connection supports both CLI and
web GUI access. See “Option 3: Connecting to ILOM Through the Ethernet Port”
on page 19 .
The following sections describe each of these methods.
Option 1: Connecting to ILOM Through the
Chassis Serial Connector
The chassis serial connector connects to the CMM ILOM, which provides a
command to connect to the server module ILOM.
▼
To Connect to ILOM Through the Chassis Serial
Connector
You can access the CMM ILOM at any time by connecting a terminal or a PC
running terminal emulation software to the RJ-45 serial port on the chassis. The
CMM ILOM’s command-line interface (CLI) enables you to connect to the server
module ILOM.
Before completing this connection, the server module must be installed in the
chassis.
1. Verify that your terminal, laptop, or terminal server is operational.