SummaCut cutter
User’s Manual
Detailed Operation
4-7
4.3.7
Overcut
The Overcut submenu enables you to generate an overcut in order to facilitate weeding the
cut. Each time the knife goes up or down, the cutter cuts a bit further. Figure 4.3 below
shows what overcut does with a tangential knife. A sample cut-out with a drag knife would
show fewer overcuts, since there would be fewer up/downs (usually only one per
curve/letter).
The overcut setting can be disabled (=0) or set to any value between 0(=off) and 10. One
unit is about 0.1 mm or 0.004 ".
FIG 4-3
4-3
OVERCUT
Press
, then use
or
to change the value. Press
to confirm or
to
cancel. The default overcut is set to 1.
4.3.8
OptiCut
OptiCut increases the cutting quality in case the knife is worn out or not calibrated correctly.
Press
, then use
or
to set OptiCut to ON or OFF. Press
to confirm or
to cancel. OptiCut is default-set to OFF.
4.3.9
Emulation Lang.
The SummaCut cutters support DM-PL , HP-GL , HP-GL/2 and Auto.
DM-PL is the recommended plotting language and usually gives the best cutting quality.
HP-GL emulates an HP 7585B, 7580B, 758X Series HPGL printer.
HP-GL emulates an HP Draftmaster RX / SX / MX 7595B type printer.
Press
, then use
or
to change the plotting language. Press
to confirm or
to cancel. The default setting is Auto.
Содержание SUMMACUT
Страница 1: ...User s Manual Rev 004...
