Procedure
1. Install the vibration box (A) on a
flat, metal surface with a minimum
thickness of 5 mm. Use the magnets
(B).
If necessary, install a metal surface to
install the vibration box on.
2. Connect the vibration box to the power
supply.
3. Connect a sensor to the vibration box.
Refer to section
on page
20.
Connect a sensor to the device
Caution: Make sure that you connect the sensors to the device correctly. If
you connect a sensor to the incorrect connection, the device does not operate
correctly or shows incorrect measurements.
Note:
• Make sure that you use the correct cable. The correct cables are supplied
with the device.
• For an overview of the connections, refer to section
Procedure
1. Remove the cover (A).
2. Connect the cable (B) to the device
(C).
3. Connect the other end of the cable to
the sensor (D).
4. Do a check if the sensor is connected
correctly.
The device screen on the dashboard
shows the indicator for the sensor if
there is a connection.
5. If the indicator for the sensor is not
available on the device screen of the
dashboard, there is no connection with
the sensor. For information, get in
contact with S.D.T.
Connect a sensor to the vibration box (optional)
Caution: Make sure that you connect the sensors to the vibration box
correctly. If you connect a sensor to the incorrect connection, the vibration
box does not operate correctly or shows incorrect measurements.
A
B
6.4
B
C
A
D
6.5
Installation
20
UM_LM2 Gears CMS_003_EN
