Note: Make sure that you use the correct cable. The correct cables are
supplied with the vibration box.
Procedure
1. Connect a cable (A) to the Vibration
connection (B) on the vibration box.
2. Connect the other end of the cable to
the sensor (C).
3. Do a check if the sensor is connected
correctly.
The vibrations tab on the device
screen of the dashboard shows the
indicator for the sensor if there is a
connection. For information, refer to
on page 34.
4. If the indicator for the sensor is not
available on the device screen of the
dashboard, there is no connection with
the sensor. For information, get in
contact with S.D.T.
Connect the vibration box (optional) to the device
Procedure
1. Connect a cable to the Vibration
Connection port on the device (A).
2. Connect the other end of the cable to
the LM2 Gears port on the vibration box
(B).
3. Connect a cable to the Vibration Config
port on the device (A).
4. Connect the other end of the cable to
the Config port on the vibration box (B).
C
A
B
6.6
A
B
Installation
UM_LM2 Gears CMS_003_EN
21
