Sullair 02250165-411 R01, Руководство пользователя

Страница: 43 / 48

SECTION 6 WS CONTROLLER USER INTERFACE MANUAL
43
V05 Charging Switch The charging switch was open when
the START command was given due
to:
• faulty operation
• component failure Reset the fault and restart.
Should the fault re-occur, contact Sullair
service.
V06 Emergency Stop An Emergency stop signal was
received from one of the digital inputs Determine the reason for the Emergency
stop and remedy it.
V07 Saturation Trip • defective component
• motor or motor cable short Cannot be reset from the keypad. Switch
off power. If this fault appears
simultaneously with Fault 1, check the
motor and motor cables.
If the problem is not in the motor or its
cables, do not re-connect power!
Contact Sullair service.
V08 System Fault • component failure
• faulty operation
Note : Exceptional fault data record,
see the Active Fault Menu and Fault
Time Data Record for more
information
Reset the fault and restart. Should the
fault reoccur, contact Sullair service.
V09 Undervoltage DC-link voltage is less than the
minimum safe operating voltage limit.
• most probable cause: supply volt-
age too low
• variable speed drive internal fault
If there was a supply voltage loss or dip,
reset the fault and restart the variable
speed drive. Check the supply voltage. If
it was within specification at the time of
the fault, an internal failure has occurred.
Contact Sullair service.
V10 Input Line Supv Input line phase is low or missing. Check the utility supply voltage, cables
and connections.
V11 Output Phase Sv Current sensing indicates that there is
no current in one motor phase. Check the motor cables, connections and
motor.
V12 Brake Chopper Sv This fault is disabled. A display of this
message indicates that the
components or settings of the variable
frequency drive have been changed. Correct drive parameters need to be
downloaded. Contact Sullair service.
V13 VFD Undertemp Heatsink temperature is under 14°F
(-10°C) Provide supplemental heating or relocate
the variable speed drive to a warmer
location.
Table 6-3: VSD Troubleshooting Guide—Drive Faults
CODE FAULT POSSIBLE CAUSE SOLUTION
WARNING