Sullair 02250165-411 R01, Руководство пользователя

Страница: 22 / 48

WS CONTROLLER USER INTERFACE MANUAL SECTION 4
22
The list below provides an explanation of each
Operating State message that may appear in the
Normal View display. Some operating states occur
instantaneously and may not be seen by the
operator.
Initializing —Displayed as the compressor is
powered up.
Stopping —May be briefly displayed as the
compressor is being stopped via the Controller
Panel.
Manually Stopped —Displayed when the
compressor operation is stopped.
Remote Stopping —May be briefly displayed as the
compressor is being stopped remotely.
Remote Stopped— Displayed when the compressor
operation is stopped but is armed to restart. The
machine will start when the remote start contact is
close.
NOTE : The machine may start at any time
when conditions are met.
Standing by— Displayed when the compressor is
stopped and waiting for proper conditions before
restarting.
Faulting —Displayed as a fault condition is occurring.
Faulted —Displayed after a fault condition has
occurred.
Waiting for Blowdown —Displayed when the
compressor is waiting for the sump to reach a set
minimum pressure prior to starting. After the
pressure has reduced to the set level, the
compressor will start automatically.
Starting 1 —Displayed as compressor initiates stage
1 startup processes.
Starting 2— Displayed as compressor initiates stage
2 startup processes.
Starting 3 —Displayed as compressor initiates stage
3 startup processes.
Precooling the Dryer —Displayed while initially
cooling an integrated dryer with the compressor
unloaded
Loading —Displayed as the compressor begins
delivering air.
Loaded and Modulating —Displayed when the
compressor is delivering air.
Fully Loaded— Displayed when the compressor is
delivering air at full rated capacity.
Unloading— Displayed as the compressor is being
unloaded automatically.
Remote Unloading— Displayed as the compressor
is being unloaded remotely.
Running Unloaded— Displayed when the system is
running with the compressor unloaded.
Remote Unloaded— Displayed when the
compressor has been unloaded remotely.
4.7 NORMAL VIEW SERVICE
REMINDERS
Service reminders may alternately appear in the
Normal View display. See
Figure 4-7 . The Service
Reminder screen is indicated by the words
“Recommended Service:” appearing on the second
line of the display. The bottom line displays a brief
description of the recommended service required.
When a service reminder appears, the machine will
continue to operate normally, however, the
appropriate service should be scheduled and
accomplished within a short period of time.
The list below provides an explanation of the Service
Reminders that may appear in the Normal View
display. Refer to
Section 5: Troubleshooting on page
27, for additional instructions on actions to be taken
when a service reminder appears.
Change Fluid Filter— The compressor fluid filter
should be changed within the time frame noted in the
machine operation specifications.
Change Separator— The compressor fluid separator
should be changed within the time frame noted in the
machine operation specifications.
Change Air Filter— The compressor air filter should
be changed within the time frame noted in the
machine operation specifications.
Analyze Fluid— A fluid analysis should be scheduled
per machine operation specifications.
Change Fluid— The compressor fluid should be
changed within the time frame noted in the machine
operation specifications.
Maintenance— Periodic maintenance should be
scheduled per machine operation specifications.
Figure 4-7: Controller Display Normal View:
Service Reminder