General Safety
7
II. Placement of Fastir Safety Decals
Yearly and prior to equipment use, ensure that all
decals and shields are in legible condition and in
place according to these drawings. Replace missing
or damaged safety decals or shields free of charge
by contacting Sukup Manufacturing Co. by mail at
Box 677, Sheffield, Iowa 50475; by phone at 641-
892-4222; or by e-mail at [email protected].
Figure 1
- Placement of Safety Decals on Carriages
Decals #1, #2, and #5 are factory-mounted. If their
replacement is necessary, follow steps below.
1 Before replacing Decals #1, #2, and #5:
1.1 Disconnect electricity.
1.2 Wire end of crosstube to track.
1.3 Ensure hairpin clips are through holes in
motor mount.
2 Ensure areas of placement for decals are free
from grease, oil and dirt.
3 Mount decals without standing under machine.
Decal #2-L0271
Decal #1-L0284
Decal #5-L0260
Figure 2
- Placement of Safety Decals on Outside of Bin
Decals #3 and #4 must be mounted on-site:
1 Ensure areas of placement for decals are free
from grease, oil, and dirt.
2 During machine installation, mount decal #3 on
bin sheet near door handle and at all other entry
points or by ladder going up to roof so everyone
entering bin will see it. See above.
2.1
Note:
If suggested areas of placement for
decals are not clearly visible, place safety
decals in a more suitable area. Never cover
up any existing safety decals.
3 Mount decal #4 on bin sheet near door handle.
See above.
Decal #3-L0258A
Decal #4-L0281
Содержание Fastir
