Sukup Fastir, Инструкция и каталог запасных частей для владельца

Страница: 10 / 70

Assembly & Installation
10
A
SSEMBLY
& I
NSTALLATION
I.
Installing Track
For part numbers and descriptions of parts
referenced in this section, see parts assembly
manual, page 53.
Track is most easily installed while first ring of bin is
being assembled on the ground. Track of correct
size must be installed as a unit in bin. Track brackets
and curvature vary according to bin diameter.
The process for installing track on some Sukup bin
sheets differs slightly from that used with bin sheets
produced by other companies. Section A describes
the process used with Sukup track-punched bin
sheets. Section B describes the process used with
Sukup bin sheets not punched for track and for non-
Sukup bin sheets.
With bin sheets produced by other companies, the
existing holes in top bin sheets may be used for
mounting track in many cases (Section B). However,
in some cases, no holes will match and all holes
must be drilled in bin sheet to mount track. Section
C describes this process.
Figure 3 - Head-On View of Track Bracket Placement
A. Installing Track on Sukup Bin Sheets
Punched for Track
A1 For Sukup bins smaller than 30’, insert 5/16” x 1-
1/4” bolts in top hole of every other pair of bolt
holes for track around top of bin (approximately
18” spacing). For Sukup bins 30’ and larger,
place bolts in top hole of every pair of bolt holes
(approximately 9” spacing) except those at bin
wall seam. Figure 3 , Figure 4 .
A2 Mount 1 length of track with bolts through top
holes on track brackets. Figure 3 , Figure 4 .
A2.1
Note:
On bins 30’ and larger with a double-
bracketed track, a gap has been left to
prevent interference between seam bolts
and track brackets. Install first section of
track with seam in place of missing bracket.
Figure 3 .
A3 Insert 5/16” x 1” bolts through bottom holes on
track brackets.
A4 Place 5/16” nuts onto bolts through track
bracket. Do not tighten at this time. Figure 4 .
Figure 4 - Side View of Track Mounted on Sukup Bin
Sheet Punched for Track
A5 Mount remaining track sections using steps A2-
A4, joining track sections together with 3/8” x 1”
bolt and 3/8” lockwasher and nut. Tighten using
9/16” wrench. Figure 5 .
A5.1
Note:
Ensure these bolts are pointing to
outside (toward bin sidewall) to avoid
obstructing machine movement.
Figure 5 - Top View of Track Splice
A6 Tighten 5/16” nuts on bolts through track bracket
using 1/2” wrench.
A7 Ensure entire length of track and bin wall is free
of any obstructions that could hinder movement
of machine through bin.
B. Installing Track on Sukup Bin Sheets Not
Punched for Track and on Bin Sheets from
Other Companies
B1 For bins smaller than 30’, insert 5/16” x 1-1/4”
bolts in single ring of bolt holes around top of bin
(approximately 18” spacing). For bins 30’ and
larger, place bolts in every bolt hole
(approximately 9” spacing) except those at bin
wall seam. Figure 3 .
B2 Tighten 5/16” spacer nuts onto these bolts.
Figure 6
.
B3 Mount first segment of track over bolts and screw
on a second 5/16” nut. Figure 3 , Figure 6 .