SUHNER ABRASIVE ROTOfera, Техническая документация

Страница: 26 / 64

When the tool is not being used unplug the power
connector.
3.2 A
brAsives
Speed rating on the abrasive is equal to or greater
than the speed adjusted on the machine.
Exclusively abrasives from the SUHNER catalog
are to be used.
Threat and store abrasives appropriately.
Damaged abrasives discs may not be used.
Always switch off the machine before changing the tool
or abrasive.
3.3 i
nitiAtion
s
Afety
i
nstructions
During operation avoid sharp bendings of the flex-
ible shaft. Excessively small bend radius will result
in premature wear. Strong whipping movements
and convulsions of the flexible shaft are signs of overload-
ing. As countermeasures use smaller tool or increase ro-
tational speed. However, this only in stict observation of
the instructions on the maximum allowed circumferential
speed of the respective tool.
4. S
ERvICE
/ m
aINTENaNCE
4.1 p
reventive mAintenAnce
4.1.1 m
AintenAnce of the mAchine
Dry the machine and keep clean in stor-
age.
Keep cooling air openings unclogged.
Regularly check connection line. Have defective lines or
connectors replaced. Have repairs done by a technician
only.
Do not spray down with water. Clean surface with lightly
moistened rags.
In case the machine is operated in one gear position only
one must at least once a week switch through all posi-
tions for a brief period in order to redistribute the grease
for l ong gear service life (run without flexibel shaft and
handpiece).
4.1.2 m
AintenAnce of the flexible shAft
Store flexible shafts in dry and clean condition.
New or freshly greased shafts require a run-in
time of approx. 1 hour.
In case of daily use lubricate monthly:
Pull shaft core out of protective tubing. Remove old shaft
grease. Lubricate shaft core with shaft grease only lightly
(1 kg can, order no. 904 832). Replace worn shaft core
(see SUHNER catalogue). Keep hose coupling in clean
- lightly greased condition. Replace worn couplings (see
SUHNER catalogue).
4.2 s
pAre pArts
See page 4-9.
4.3 r
epAir
If the machine strict observance of the manufacturing and
testing method the tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
Any replacement needed for the connecting line must be
installed by the manufacturer or its agent if safety risks are
to be eliminated.
4.4 w
ArrAnty
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages.
Complaints can only be honored if the machine is re-
turned in the undisassembled condition.
4.5 s
torAge
Temperature range during operation: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C
4.6 d
isposAl
/ e
nvironmentAl compAtibility
The machine consists of materials which can be recycled
in a recycling process.
Before disposal, render the machine unusable.
Do not throw the machine into the garbage collec-
tion
According to national regulations this machine must be
recycled in an environmentally-friendly manner.
26
CN
PL
CZ
FI
SE
NL
PT
ES
IT
EN
FR
DE
EN