Page 26
Component Removal
Warming Drawer WWD30-2
4-3
#814750 - Revision A - January, 2011
Stainless Steel Drawer Box
The side flanges of the stainless steel drawer box rest
on top of the drawer frame.
To remove the drawer box, open the drawer until the
stops are engaged. Then, at the center of left and right
side flanges lift drawer box. (
See Figure 4-1
)
Drawer Removal
NOTE
:
See all Warnings and Cautions at beginning of
Section.
1. Disconnect Electrical Supply to Unit.
2. Stainless steel drawer box must be removed from
drawer.
3. Open drawer fully. Reach inside of unit cavity and
disconnect control cable plug from jack located on
inner back of unit.
4. Release the control cable from the cable hold down
clips and place free section of control cable in draw-
er.
5. The drawer can be separated from slide assemblies
by moving drawer release up for the left side and
down for the right and pull for the bottom. (
See
Figures 4-2 & 4-3
)
NOTE
:
It is usually better to leave the two sections of
the slides engaged until all three slides are released
from their latch mechanisms. This way they can help
support the drawer until all three can be separated.
6. The drawer assembly can now be removed from the
Warming Drawer Cavity.
NOTE
:
Upon reassembly control cable must be
arranged to avoid damage to cable.
(
See Figure 4-4
)
Drawer is heavy, use care not to damage drawer
slides or scratch frame of unit.
Figure 4-1. Stainless Steel Drawer Box Removal
Figure 4-2. Left Drawer Release
Lift Here
Lift Here
Figure 4-3. Bottom Drawer Release
Pull
Figure 4-4. Control Cable Routing
ELECTRICAL SHOCK HAZARD - DISCONNECT
ELECTRICAL SUPPLY TO UNIT BEFORE ATTEMPT-
ING THE FOLLOWING PROCEDURES.
