Lynx LMD-4, Инструкция по установке

Страница: 1 / 5

P/N# 35832 1
Installation of the Modular Drawer
LMD-4
The following instructions are provided to help you install the Lynx Modular Drawer.
Tools required: Rags, Newspaper or similar (to set the drawers on), and Gloves
STEP 3- PLACE THE DRAWER FRAME INSIDE THE PRE-CUT HOLE IN THE FRONT OF THE ISLAND (PER CUT-OUT DIMENSIONS
ON PAGE 4). CAREFULLY SLIDE THE FRAME ALL THE WAY IN UNTIL THE FRONT FLANGE IS FLUSH WITH THE ISLAND FRONT
SURFACE. USE THE #8 X 1-1/2" SCREWS AND FINISHING WASHERS PROVIDED TO SECURE FRAME. IF FRONT SURFACE IS A
HARD MATERIAL, IT MAY BE NECESSARY TO DRILL PILOT HOLES WITH A 1/8 TO 5/32 DRILL BIT.
STEP 4- IT IS RECOMMENDED THAT THE REAR OF THE DRAWER FRAME BE SUPPORTED IN ORDER TO UTILIZE THE FULL
CAPACITY OF THIS HEAVY DUTY DRAWER SYSTEM. THERE ARE 2 METHODS TO ACCOMPLISH THIS.
METHOD #1- SECURE A VERTICAL SUPPORT , INSIDE THE ISLAND, 23-3/8" BACK FROM THE INSIDE EDGE OF THE ISLAND
FRONT. A COMMON 2 X 4 CAN BE USED FOR THIS PURPOSE. USE THE SHORTER #10 X 1/2" SCREWS PROVIDED AND SECURE
THE BACK OF THE DRAWER FRAME TO THE SUPPORT BY DRIVING THE SCREW THROUGH THE BACK FRAME AND INTO THE
SUPPORT.
METHOD #2 - SEE PAGE 2.
STEP 5- REINSTALL DRAWER INTO DRAWER FRAME ASSURING FIRST THAT THE BALL BEARING TRACK IS POSITIONED
TOWARD THE REAR OF EACH SLIDE. ALIGN SLIDES AND PUSH DRAWER FIRMLY INTO FRAME AND ALL THE WAY TO THE
CLOSED POSITION BEFORE ATTEMPTING TO RE-OPEN. RESISTANCE WILL OCCUR DURING THE INSERTION PROCESS.
DO NOT ATTEMPT TO OPEN DRAWER BEFORE IT HAS BEEN INITIALLY FULLY INSERTED.
START:
STEP 1- REMOVE DRAWER FROM OUTER SLIDE FRAME BY SLIDING DRAWER OUT AWAY FROM
FRAME UNTIL DRAWER STOPS. DISENGAGE THE DRAWER SLIDE BY ACTIVATING THE RELEASE
LEVERS. PRESS DOWN ON THE RIGHT LEVER AND UP ON THE LEFT LEVER. CAREFULLY PULL
DRAWER COMPLETELY AWAY FROM SLIDE.
STEP 2- BEFORE PROCEEDING, PUSH THE REMAINING PORTION OF THE SLIDE (MOUNTED IN THE
FRAME) ALL THE WAY IN AND SLIDE THE BALL BEARING TRACK OF THE SLIDE ALL THE WAY BACK
UNTIL IT STOPS.
INSTALLATION OF MODULAR DRAWER