Subtronic Pro 160 Fusion, Руководство пользователя

Страница: 11 / 20

form up the flash capacitor
During longer storage the installed capacitor change its physically condition. Please form
up the capacitor every 6-8 weeks. Therefore connect the camera with your flash, switch on
the system for approx. 15 min and trigger two or three times on full power.
ttl- check
We recommend with every change on the system ( changing cables or camera )a
check of the ttl-mode:
Flash in ´Auto´- mode directly in the objective of the camera. The result is a very slow
flash. After that cover the objective from the camera, the flash fires full power after
pushing the trigger.
Please note:
Test shoots with analogical cameras delivers only correct results if film is installed.
Digital cameras mostly needs a installed memory card.
leakage on the housing
If water penetrates into the flash gun body please follow the instructions below:
•
Switch-off the device.
•
Remove the rear cap ring (this ring doesn´t have a sealing function, but is only used
to secure the rear plate), open the lid by pulling the plug connector or the scale head
and remove the water.
•
In no way pull the electronic system out of the body, as the voltage level on the
electronic board is extremely dangerous (up to 400 V).
•
Close lid and return the device to subtronic as quickly as possible.
•
All warranty claims will become void if the lid is opened without due cause, unless
the case described above occurs during the warranty period and was caused by a
factory fault.
•
Please note that warranty claims will become void if water penetration is caused by
damage to the cables or attaching the plug connector incorrectly. All devices and
cables are subjected to an 8-hour pressure test prior to delivery.
11