Subaru Legacy 2021, Руководство пользователя

Страница: 142 / 592

(138,1)
北米Model "A2600BE-B" EDITED: 2020/ 10/ 1
Steps Operation Time
1 Sit in the driver’s seat. —
2
Close all doors and the
rear gate.
—
3
(1)
Press and hold “ ” on
the power locking
switch.
Within
10 sec.
(2)
Insert the key into the
ignition switch and pull it
out at least 6 times.
4
Open and close the dri-
ver’s door.
Within
10 sec.
The hazard warning flashers flash 3 times
to indicate completion of the setting.
Your SUBARU dealer can perform the
above procedure for you.
& Selecting Hazard Warning
Flasher Operation
Using the hazard warning flasher, the
system will give you a visible signal when
the doors are locked or unlocked. If
desired, you can turn the hazard warning
flashers off by operating the center infor-
mation display. For details, refer to “Car
settings”
F
P220 (11.6-inch display mod-
els) or “Vehicle setting icons”
F
P239 (dual
7.0-inch display models). The setting can
also be changed by a SUBARU dealer.
Consult your SUBARU dealer for details.
& Vehicle Finder Function
Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30 feet
(10 meters) of the vehicle, pressing the “ ”
button three times in a 5-second period will
cause your vehicle’s horn to sound once
and its hazard warning flashers to flash
three times.
NOTE
If the interval between presses is too
short when you press the “ ” button
three times, the system may not re-
spond to the signals from the remote
transmitter.
&
Sounding a Panic Alarm
To activate the alarm, press the “PANIC”
button once.
The horn will sound and the hazard
warning flashers will flash.
To deactivate the panic alarm, press any
button on the remote transmitter. If a
button on the remote transmitter is not
pressed, the alarm will be deactivated after
approximately 30 seconds.
&
Replacing the Battery
Refer to “Replacing Battery”
F
P525.
& Replacing Lost Transmitters
If you lose a transmitter or want to
purchase additional transmitters (up to
four can be programmed), you should re-
program all of your transmitters for security
reasons. For details, contact your
SUBARU dealer and have the transmitters
programmed into the remote keyless entry
system.
& Certification for Remote Key-
less Entry System
. U.S.-spec. models
FCC ID: CWTB1G077
FCC ID: CWTD1G141
CAUTION
FCC CAUTION
Changes or modifications not ex-
pressly approved by the party re-
sponsible for compliance could void
the user’s authority to operate the
equipment.
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received, including interference that
Remote Keyless Entry System
136