(1) Clean, degreas, and dry the shaded area
of the Rear fog cover with a degreasing
agent.
※
Remove the masking tape that secures
the U-nut.
-4-
Rear fog cover
④
Inner center
Masking tape
④
Inner center
Rear fog cover
④
Inner center
Rear fog cover
Rear fog cover
④
Inner center
④
Inner center
⑨
U-nut
⑨
U-nut
⑩
Bolt
⑩
Bolt
【
Back side view
】
【
Surface view
】
2. Install the
④
Inner center.
Crimping
Crimping
Crimping
Push
Push
Mounting reference
Pull out
Pull out
Pull out all
(5 places)
(2) Peel the double-sided tape liners of the
④
Inner center,and fix with masking tape.
( 7 places )
(3) Insert
⑨
U-nut into 3 places in the left figure.
(4) Turn the
④
Inner center over and fix it with
masking tape so that the U-nut does not fall.
( 3 places )
(5) Cover the Rear fog cover with the
④
Inner
center and align the three holes.
※
Pressing until the mounting reference of
the Rear fog cover.
Align the holes
(6) Temporarily fix the
④
Inner center with
⑩
Bolt. ( 3 places )
(7) Check the position of the hole and crimp the
shaded area in the left figure.
Crimp the whole while pulling out the liners.
( 2 places )
※
To care not deviated hole position.
(8) Pull out all the liners and crimp it.
( 5 places )
(9) Fully tighten the
⑩
Bolt. ( 3 places )
Reference tightening torque 2.0N
・m
( 0.2kgf
・m
)