Subaru 2014 Impreza STI, Руководство пользователя

Страница: 256 / 418

an additional four times. If the vehicle fails
to start after the additional attempts, the
remote engine start system will abort and
return to a non-activated state.
&
Remote start safety features
For safety and security reasons, the
system will fail to start and beep the horn
twice or shut down the engine during
remote start operation if any of the
following conditions occur.
.
The brake pedal is depressed before
the vehicle ignition switch is turned
“
on
”
.
.
The key was already in the ignition
switch.
.
The engine hood is opened.
.
The vehicle
’
s engine idle speed has
reached a level over 3,000 rpm.
.
The alarm is triggered by opening a
door or the rear gate.
NOTE
.
The security indicator light on the
combination meter will stop flashing
while under remote engine start opera-
tion, but the vehicle is still protected.
.
If the vehicle is entered during
remote engine start operation, the
system will not record entry in the
alarm history.
&
Entering the vehicle while it
is running via remote start
1. Unlock the vehicle doors using the
remote keyless entry system. If the vehi-
cle
’
s doors are unlocked manually using
the key, the vehicle
’
s alarm system will
trigger and the remote engine start system
will turn off. Inserting the key into the
ignition switch and turning it to the
“
ON
”
position or pressing the unlock button
“ ”
on the remote keyless entry transmitter
will disarm the alarm system. Refer to
“
Alarm system
” F
2-15.
2. Enter the vehicle. Do not depress the
brake pedal.
3. Insert the key into the ignition switch
and turn to the
“
ON
”
position. If the ignition
switch is accidentally turned to the
“
START
”
position, the system
’
s
“
starter
anti-grind
”
feature will prevent the starter
from re-cranking.
4. Depress the brake pedal. The remote
starter disengages, the vehicle
’
s power
window features are re-enabled and the
vehicle will operate normally.
&
Entering the vehicle follow-
ing remote engine start shut-
down
An alarm trigger may occur if the vehicle is
opened by the remote keyless entry
transmitter within a few seconds immedi-
ately following remote engine start shut-
down.
&
Pre-heating or pre-cooling
the interior of the vehicle
Before exiting the vehicle, set the tem-
perature controls to the desired setting
and operation. After the system starts the
vehicle, the heater or air-conditioning will
activate and heat or cool the interior to
your setting.
&
Service mode
In service mode, the remote start function
is temporarily disabled to prevent the
system from unexpectedly starting the
engine while being serviced.
!
To engage the service mode
Turn the ignition switch to the
“
ON
”
position, depress and hold the brake
pedal, then press and release the
“ ”
button on the remote engine start trans-
mitter three times. The system will pause
for 1 second and then flash the turn signal
lights and honk the horn three times
indicating that the system is in service
mode. When attempting to activate the
remote start system while in service
mode, the turn signal lights will flash and
the horn will honk two times and will not
Starting and operating/Remote engine start system (dealer option)
7-11
–
CONTINUED
–