subzero.com
|
9
OPERATION
WATER FILTER REPLACEMENT
1
To access the water filter, pull out on the bottom edge
of the grille assembly and rotate upward.
2
To remove the old filter, rotate counterclockwise one-
quarter turn, then pull out. Refer to the illustration below.
It is normal for a small amount of water to drip when
the filter is removed. It should be wiped up with a paper
towel or cloth.
3
Remove the new filter from packaging and remove
plastic cap.
4
Insert the new filter into the manifold and turn clockwise.
5
Once the new filter has been installed, press and hold
the water filter reset button for five seconds to reset.
Refer to the illustration below.
Water Filtration System
The water filtration system of Sub-Zero built-in models
supplies filtered water to the ice maker and water dispenser
(dispenser models) to produce great-tasting water and ice.
IMPORTANT NOTE:
When using the water filtration system
for the first time and after filter replacement, it is neces-
sary to clear any air from the system and allow the filter to
assist in cleaning the water lines. For non-dispenser models,
discard the first two full containers of ice. For dispenser
models, dispense several glasses of water for a period of
two minutes.
If the water filtration system will not be utilized, it can be
placed in water filter bypass mode by removing the filter.
The filter is rated for 750 gallons
(2839 L)
or one year,
whichever comes first. The
indicator will illuminate and
flash in the control panel display when the filter needs to be
replaced.
Replacement Sub-Zero water filters can be ordered online
at subzerowolfstore.com. For questions, contact Sub-Zero
customer care at 800-222-7820.
Water filter removal.
WATER FILTER
Water filter location.
WATER FILTER
RESET BUTTON
WATER
FILTER
