Page 8
400 Series
400 Series
Component Access and Removal
6-8
Upper and Lower Evaporator Fan Cover Access and
Removal (Model 424)
There are two access holes in the front of the evapora-
tor fan cover. The back flanges of the evaporator fan
cover have slots that line up with the access holes.
Screws inside these access holes pass through slots in
the back flanges and through holes in the evaporator
cover into screw grommets, securing the fan cover.
To remove the evaporator fan cover, extract the two
mounting screws from the access holes and pull the fan
cover forward.
NOTE:
When reinstalling the fan cover, first insert one
of the two mounting screws through the evaporator
cover, into the screw grommet, but do not fully tighten.
Then, slide the corresponding slot in the rear flange of
the fan cover over the screw and rotate the fan cover
up until the other access hole lines up with the other
mounting hole. Insert the second screw and tighten
both screws.
Upper Evaporator Cover Removal (Model 424)
To remove the upper evaporator cover, first remove the
two wine racks and all cabinet slides, cabinet slide
spacers and cabinet slide support spacers in the upper
compartment. Then, remove the evaporator fan cover
mounting screws and the evaporator fan cover. Pull the
evaporator cover forward slightly. Push the thermistor
leads and grommet out of the slot on the left-hand side
of the evaporator cover. There is a ground wire riveted
to the back of the evaporator cover, and the other end
of the ground wire has a screw securing it to the rear
wall. Extract the ground screw and pull the evaporator
cover out.
NOTE:
When reinstalling the evaporator cover, the
ground wire must be reattached to the rear wall with the
ground screw .
Lower Evaporator Cover Removal (Model 424)
To remove the lower evaporator cover, first remove the
three wine racks in the lower compartment. Then,
remove the evaporator fan cover mounting screws and
the evaporator fan cover. Pull the top of the evaporator
cover forward and lift off of pegs at bottom. You'll find
a ground wire riveted to the back of the evaporator
cover, and the other end has a screw securing it to the
rear wall. Extract the ground screw and pull the evapo-
rator cover out.
(See Figures 6-12, 6-13 & 6-14)
NOTE:
When reinstalling the evaporator cover, the
ground wire must be reattached to the rear wall with the
ground screw .
Figure 6-12. Evap Fan Cover Removal
Figure 6-13.
Ground Screw Wire & Screw
Figure 6-14.
Lower Evaporator Cover Removal
Evaporator Fan Cover
Screw Access Hole
Evaporator Cover
Ground Screw
Evaporator Cover
Mounting Screw
Pull top of evap
cover forward and
lift off of pegs
Lower Evap
Cover
Peg
