In this menu you can configure the LNB and switches
for each satellite.
Satellite: Up to 40 satellite alternatives are
available, and 29 satellite alternatives are
already preprogrammed as Astra, Hotbird,
Turksat, Arabsat, etc. Select one preprogrammed
satellite that corresponds to your antenna. If you have a
satellite configuration which is not preprogrammed,
refer to the Transponder Edit menu.
LNB Frequency: Selection is possible for different kinds of LNB’s. Select the frequency for
the LNB, which is valid for your combination.
The LNB alternatives are:
“Universal”, “5150”, “5750”,“9750”,“10600”,“10700”,“11300” MHz, ,
If you select Universal, both 9750MHz and 10600MHz are supported at the same time, and
22KHz is set to “AUTO”. If you have a special LNB type, you can enter the new frequency
with the numbered keys 0-9.
DiSEqC switch: There are in principle two kinds of external DiSEqC switches on the market.
One for connection of two LNB’s, the other one for connection of up to 4 LNB’s. Select the
LNB Input A/B/C/D for each LNB connected to the respective switch port of the DiSEqC
Switch.
22KHz: If the STB is connected to a dual LNB or two antennas are connected to a 22KHz
tone switch, select “ON”, in case of a Universal LNB, the mode is “AUTO”.
0/12V (
option
) : If you have connected a 0/12V switch, select between 0 and 12V
DiSEqC Positioner: If you have connected a DiSEqC 1.2 Actuator system, salect the
DiSEqC Positioner mode to “1.2”.If you have connected UCAS system, select to “1.3”
LNB setup
