- 6 -
Programming Instructions
The STX Dehydra 600W-SST Food Dehydrator is equipped with a 40
hour timer. (See illustration of Control Panel on page 7.) This unit will
NOT HEAT/RUN until the timer and temperature controls are completely
set and started. The START/SEL button has TWO functions - 1) to
select time or temperature AND 2) for starting the unit once the time and
temperature have been set.
1. Turn the power switch to the ON position. The LED will light up.
2. Set the Timer
a. Press and hold the START/SEL button until the hour display starts
flashing.
b. Select the hours desired by pushing the UP or DOWN button under
the timer.
c. Press the START/SEL again and the minute display will start
flashing.
d. Select the minutes desired by pushing the UP or DOWN button
under the timer.
3. Set the Temperature
a. Press the START/SEL again to select the tempertaure display.
b. Select the desired temperature by pushing the UP or DOWN
button under the temperature display.
Note: Please refer to the Temperature Conversion Table on pg 7 of
the manual as needed.
4. Press the START/SEL button and all digial displays will stop flashing.
5. Once you verify your settings are correct, press the START/SEL
button again to start the unit.
6. To temporarily stop the dehydrator without losing the previous time
and temperature settings, press the START/SEL button. To restart
again, press START/SEL.
7. To stop the dehydrator, turn the ON/OFF button to OFF.
