4
BEFORE USING
Read all cautions and warnings to page 2 prior to install this equipment. Particularly, read the follow:
1) Disconnect power before lamp’s replacement or servicing (service personnel)
2) Do not open the lamp cover for 300 seconds after switching off
3) Wear gloves and goggles to re-lamping or to work inside the unit (service personnel)
Before connecting the equipment to the power system: make sure that the mains voltage and frequency correspond to rated
values.
• The fixture is equipped for a mains voltage 95-265VAC, 47-63Hz.
The power supply cords construction is shown in pict.1. For connection to the mains supply proceed as pict.1.
The equipment must be connected to branch circuit having a circuit-breacker In=10A • Id=0.03A (230VAC)
a) Do not install the spot close to the heat sources. Observe minimum distance between the fixtures of 1.5 meters. Do not lay the
connection cable on the spot when it is warm.
b) This unit must be positioned as to allow its ventilation.
c) The unit must be positioned at least 50 cm. from walls or other flammable surfaces.
d) Observe minimum distance to lighted objects of 5 meters.
External surface temperature Ta 35°C:
• After 10 minutes work; Tc=75°C.
• Once the thermic balance has been obtained; Tc=100°C.
4) The protection screens, the lenses, or the ultraviolet filters must be replaced if they are visibly damaged and their effectiveness
has been reduced, for example, by cracks or deep scratches.
5) The lamp must be replaced if it has been damaged or thermally deformed.
6) Do not handle the spot by taking it by the head, but always by using the special handles.
WARNING
!
pict.1
INPUT CONNECTOR IP 68
3 PIN CONNECTOR FOR DMX LINE
CIRCUIT - BREAKER
MAINS VOLTAGE
In
Id
230V
10A
0,03A
CONDUCTOR SIZES (length < 20mt.)
MAINS VOLTAGE
CROSS SELECTIONAL AREAS
230V
3X1,5 mm
2
(minimum)
110V
3x2,5 mm
2
(minimum)
The equipment must be earthed. If this rule is not followed, the warranty will be void.
N = NEUTRAL
L = LIVE
= EARTH
pict.2
