Studer Innotec SA
Xcom-485i
6
User manual
3
MATERIAL NEEDED FOR THE INSTALLATION
3.1
C
ONTENTS OF THE
X
COM
-485
I COMMUNICATION SET
The Xcom-485i communication set contains the following material:
3.2
O
THER REQUIRED MATERIAL
In addition to the material delivered with the communication set the use of an Xcom-485i
necessitates a cross-headed screwdriver #1 (P1).
Since the Xcom-485i is dedicated to communicate with a third-party system (SCADA, PLC etc.) you
will need a specific cable crafted with the proper connector and pinning on each side. See
chapter 5.2.
One Xcom-485i module
Two 2 meters communication cables, to connect
the Xcom-485i to Studer and external devices
Mounting plate
2 DIN rail clips and screws
SD card with manual
This device should not be used for any purpose not described in this manual. The device
is using RJ45 connectors frequently used and standard for LAN (Local Area Network).
The Xcom-485i should never be used or plugged into communication networks other
than the ones specified in this manual. This will seriously damage the product.
