Installation and connection
5
Installation and connection
5.1
Check operating conditions
1. Ensure the design of the
fi
tting is consistent with the pur-
pose intended:
–
Materials used (
→
Type plate).
–
Medium (
→
Order and design data).
2. Ensure the required operating conditions are met:
–
Resistance of the body materials and seals to the
medium
–
Media temperature (
→
Data sheet).
–
Operating pressure (
→
Data sheet).
3. Consult with the manufacturer regarding any other use of
the device.
5.2
Installing the pilot solenoid on
the pneumatic valve
WARNING
Risk of injury due to high pressure!
Switch off the compressed air supply to the system and the
fi
tting.
Make sure that the compressed air hoses are depressur-
ized and empty.
WARNING
Risk of poisoning and environmental damage from
medium!
Leak due to faulty installation.
Installation work on the pipes downstream of the pneumatic
fi
tting should be performed only by technicians who have
been specially trained for the pipework in question.
NOTE
Material damage due to contamination of the fitting!
Make sure no contamination reaches the
fi
tting.
NOTE
Material damage from incorrect installation of fitting
Use suitable tools.
Comply with the manufacturer’s instructions regarding
installation of the pneumatic valve.
1
2
3
Fig. 4
Installing the pilot solenoid on the pneumatic valve
1. Slide the O-ring supplied on to the threaded spigot (1).
2. Install the
fi
tting with the magnetic preferably aligned
upwards.
3. Then attach the
fi
tting to the pneumatic valve with the
screw (3)
9.1.3 Tightening torques, Page 11).
4. Screw the compressed air line into the tapped socket (2).
5.3
Connect fitting to electrical system
Power supply switched off and secured against being
switched back on again.
DANGER
Risk of electrocution!
All electrical work must be carried out by quali
fi
ed electri-
cians only.
Switch off the system power supply and secure it against
being switched back on again.
1. Ensure correct current type and voltage before electrical
connection (
→
Data sheet).
2. Ensure that the plug connection is protected against per-
manent dampness. Provide cover as needed.
3. Connecting cable to connector
9.3 Plug assignment, Page 11).
4. Insert the connector into the connector socket of the
fi
tting.
If necessary, rotate the device socket through 90° until the
desired position of the device socket is achieved.
301 302
BA-2017.10.18 EN
type 6014
7
