
18
2236-009-101 REV B
WARNING
• Unplug the control unit from its power source. Failure to do so could result in personal injury or equipment
damage.
• Do not expose the unit to excessive moisture that would allow for liquid pooling. Personal injury or equipment
damage could occur.
CAUTION
• Do not use harsh cleansers/detergents, such as scouring pads and heavy-duty grease removers, or solvents, such
as acetone. Equipment damage could occur.
• Do not use any steam cleaning device on the unit.
CONTROL UNIT
Wipe off dust. If necessary, clean the housing exterior with a disinfectant solution or a mild detergent and a damp cloth.
Then wipe dry.
GENERAL CLEANING
If there is no visible soilage with possible body fluids, we recommend that you clean the mattress system with a mild
detergent and warm water. If disinfection is desired, you may use a combination cleanser/disinfectant as explained in
“Disinfecting” section.
• Patient care equipment that does not come in contact with mucous membranes or non-contact skin requires low-level
disinfection. Wiping surfaces with a properly prepared detergent or disinfectant carries out low level disinfecting.
• Processing of dirty patient care equipment should take place in a designated area away from clean or sterile
supplies and food preparation areas.
• Detergent/disinfectants should not be mixed with other germicides or detergents. Using the proper dilution insures
the most effective killing power of the disinfectant.
• Wash hands often and well, including after removal of gloves.
• Patient care equipment that is used in isolation areas should be disinfected in accordance with all internal policies
and procedures regarding such equipment.
DISINFECTING
When there is visible soilage, and between patients, it is recommend that the unit and mattress be disinfected with a
tuberculocidal disinfectant. Disinfectant should be registered with the Environmental Protection Agency (EPA).
• Use rubber gloves and eye protection.
• Prepare detergent/disinfectant (registered by EPA as hospital disinfectant) solution according to instructions on label
for correct use-dilution.
• With support surface deflated, thoroughly wipe down entire mattress, as air cells will lie flat. Be sure to reach all
areas underneath and in-between air cells. Allow to air dry.
• If dust or other soiling has accumulated along air hoses, remove using swabs moistened with detergent/disinfectant
as necessary. Allow all components to air dry. Wrap mattress in plastic and return to storage area.
• Thoroughly wipe down outside of control unit and allow to air dry. Cover with plastic and return to storage area
• Remove gloves and dispose; wash hands.
Cleaning, Storage and Care