Struers Unitom-5, Инструкция по эксплуатации

Страница: 46 / 264

Unitom-5
Instruction Manual
42
Quick Reference Card
„
Place the workpiece between the clamp and the back stop at the
right hand cutting table.
„
Push the clamp towards the workpiece and lock the quick-clamping
device with the locking handle.
„
Lower the cut-off wheel into correct position above the workpiece by
pressing POSITION DOWN
V
. The cut-off wheel should be min. 1
mm above the workpiece.
„
Carefully close the protecting guard.
„
Press START
s
. The cut-off wheel starts rotating and the cooling
water starts running.
„
Unitom-5
automatically stops cutting when the sample has
been cut through (default setting). The cut-off wheel moves to
start position (default setting). The cut-off wheel stops
rotating and the cooling water stops.
„
Press STOP
o
and the cutting process stops. The cut-off wheel
moves to start position (default setting). The cut-off wheel stops
rotating and the cooling water stops.
The feed speed can be set before the cutting and changed during the
cutting.
„
Press ENTER
e
to edit the value.
„
Press MENU UP/DOWN
mON
to change the value.
„
Press ENTER
e
to accept the new value.
„
Open the protection guard and swing the right cooling tube to the
right.
„
Press the black locking knob and turn the cut-off wheel until the
spindle lock clicks.
„
Remove the nut with a spanner. Remove the flange and the old cut-
off wheel.
„
Mount the new cut-off wheel. Mount the flange and the nut. Tighten
carefully.
„
Swing the right cooling tube back into position.
„
Point the cleaning hose towards the bottom of the cutting chamber.
„
Turn the cooling valve clockwise to flushing position.
„
Clean the cutting chamber.
„
Turn the cooling valve counter-clockwise to cooling position.
„
Always leave the protection guard open to let the cutting chamber
dry.
Clamping the Workpiece
Starting the Cutting
Stopping the Cutting
Automatic Stop
Manual Stop
Change Feed Speed
Changing the Cut-off Wheel
Flushing the Cutting Chamber