Struers Exotom 100, Инструкция по эксплуатации

Страница: 54 / 247

Exotom-100
Instruction Manual
48
Quick Reference Card
Place the workpiece between the clamp and the back stop on
the right hand cutting table.
Push the clamp towards the workpiece and lock the quick-
clamping device with the locking handle.
Position the cut-off wheel.
Close the protection hood.
Press START
s
. The cut-off wheel starts rotating and the
cooling water starts running.
In the Cutting Menu, toggle between FORCE/FEED/STOP
pushing the knob, until STOP is highlighted.
Turn knob to move pointer to setting AUTO at the bottom of
the STOP column.
Press STOP
o
and the cutting process stops. The cut-off
wheel stops rotating and the cooling water stops.
Press MENU
m
once if CONFIGURATION MENU is selected.
Push knob to toggle between parameters in the Cutting Menu.
Turn knob to edit the value of the selected parameter.
Push knob to move to next parameter.
Press the knob for the spindle lock and turn the cut-off wheel
until the spindle lock clicks.
Remove the nut with a fork spanner (30 mm).
Remove the flange and the cut-off wheel.
Mount the new cut-off wheel.
Mount the flange and nut. Tighten carefully and close the
guard.
Point the flushing hose towards the bottom of the cutting
chamber.
Press the lever on the flush nozzle to turn the water on.
Adjust the flow using the lever.
Clean the cutting chamber thoroughly.
Turn off the water by releasing the lever on the flush nozzle.
Clamping the Workpiece
Starting the Cutting
Stopping the Cutting
Auto Stop
Manual Stop
Setting the Cutting Parameters
Changing the Cut-off Wheel
Cleaning the Cutting Chamber