Struers Exotom 100, Инструкция по эксплуатации

Страница: 15 / 247

Exotom-100
Instruction Manual
9
Check that the nylon sieve in the filter drawer is properly placed and
close the drawer.
Mount the drain hose on the back of the machine.
Place the recirculation cooling unit in the compartment.
Fill the cooling unit with 150 l of water (5-10 cm from the upper
edge).
Use additive enclosed with the machine and add to cooling water as
specified on the bottle label and stir.
Exotom-100 may be directly connected to the water mains.
Connect the water inlet fitting (½” internal, ¾” external thread).
Open the external water supply.
Fill the cooling unit with 150 l of water (5-10 cm from the upper
edge).
Shut off the water.
Add additive in the quantity stated on the bottle label and stir.
Setting Up the
Recirculation Cooling Unit
IMPORTANT
The cooling unit must be positioned inside the compartment as indicated by
the arrows on the edge of the cooling unit.
Direct Water Supply for the
Cooling Unit
IMPORTANT
When the cooling unit is pushed into the compartment, care should be
taken that the flushing hose is not trapped behind it.
To counter this, pull the flushing hose all the way out of its holder, then
replace. The flushing hose, should then rest inside the cooling unit.