Struers Abramin, Инструкция по эксплуатации

Страница: 14 / 137

Abramin
Instruction Manual
10
Check that the serial plate which is placed above the wire (fig. 3.

),
is marked with the correct voltage and frequency.
Connect the wires (fig. 3.

) as follows:
Yellow/green: earth
Black: phase
Black: phase
Brown: phase
Check that the turntable rotates counter-clockwise when "Disc" is
activated. If it rotates clockwise, reverse the direction by changing
over two phases. The voltage must not deviate more than 10% from
that indicated on the serial plate, otherwise damage can be caused
to the electronics or the power can be reduced.
Connect the thin reinforced hose (fig. 3.

) to the tap and use a
13 mm hose clip to secure it. The supplied hose connection with
union and gasket can also be mounted on the tap (½" pipe thread BS
2779:G ½).
Connect the outlet hose to the union on Abramin. The hose is led to
the outlet in a gradual slope. This prevents the water from
discharging too slowly as this may cause overflow or blocking of the
outlet. The elbow pipe must be suitably placed in order to prevent
elbows on the hose.
For the outlet hose use hose clip (30 mm). It must not be tightened
too much (plastic tubing).
If the built-in lubricator is to be used, the apparatus is ready for use
when the 250 ml bottle is full of lubricant, the special stopper is set in
and the bottle in position as shown on fig. 1 in the Spare Parts
manual.
If Multidoser is to be used, connect it to the multiple socket on the
right side of the apparatus.
Connection to Mains
Connection of Water
Lubricator