Strongway 49167, Руководство пользователя

Страница: 9 / 19

Page 9 of 19
Step 4: Assemble Long Side of Axle Shaft
Step 4 Hardware Needed:
1
– Middle Brace (2)
2
– Double Spool Assembly (10)
1
– 2.11” Spacer Tube (31)
1
– 5.29” Spacer Tube (32)
2
– 1” Spacer Tube (30)
3
– Flat Washer 7/8” (34)
Assemble below items onto LONG SIDE of the
Axle Shaft (6) in the following order:
1.
Start with 1” Spacer Tube (30)
2. Flat Washer
7/8” (34)
3. Middle Brace (2)
4. Flat Washer
7/8” (34)
5.
2.11” Spacer Tube (31)
6. Double Spool Assembly (10)
7. 5.29
” Spacer Tube (32)
8. Double Spool Assembly (10)
9.
1” Spacer Tube (30)
10. Flat Washer
7/8” (34)
Note the Plug Knives (15) should face the same direction
when assembled.
See Figure 4.
Step 5: Attach End Plates & Wheel Bracket
Step 5 Hardware Needed:
2 - End Plates (3)
2 - Wheel Brackets (9)
2
– Flat Washers 7/8” (P)
2
– Hex Bolts 1/4” x 1-1/2” (B)
2
– Lock Nuts 1/4” (T)
Start by rotating the Wheel Bracket (9) in the
middle of the Axle Shaft (6) so it is pointing
upward. Attach one End Plate (3) to one side,
followed by Flat Washer
7/8” (P), followed by a
Wheel Bracket (9).
Note in Figure 5: Wheel Bracket ring faces inward.
Fasten Wheel Bracket (9) to Axle Shaft (6) using
Hex Bolt
1/4” x 1-1/2” (B) and 1/4” Lock Nut (T).
Fully tighten connection. Repeat for the opposite side.
Figure 4
Figure 5
1/4” x 1-1/2” Hex Bolt
2.11” Long
Spacer
End Plate